Yesterday I bought a glass bottle, I clean it and rinsed it with water. I want to use it for mixing/shaking up my juice before putting it onto another bottle. But I cant seem to dry it all out and now the question is - Does a few drops of water affect the juice ? it's not distilled water it's just normal water from the tap
It will dry, eventually. You don't want tap water mixing with your juice.
Why are you shaking in one bottle and then transferring?
Because I mixed a 50ml bottle with some nicotine base and my black mamba flavour but it wont mix properly it looking like gel in the middle of the bottle wo I want to have a bigger bottle to shake it up in properly
Gel?
Buy some cheap, but sturdy, paper towels.
It might seem a bit maticulous, but using a dry paper towel to sort of twist up and shove into the bottle for a few turns has been pretty successful for me as far as drying and removing any water (and by extension, prevention of water stains) that might be left after a good rinse.
Also they're just a really great piece of equipment to have in ones ~~mixing~~ toolkit.
"Always remember where your towel is."
I have good towels but I cant seem to get it around the edges of this bottle 😅
Probably the shoulders, up near the neck, if I were to guess correctly?
If so, I'd only be able to suggest trying to get creative with how you could maneuver the towels.
I was pretty lucky with my worst offending bottles, and was able to get my pinky into the neck enough to press down onto the paper towels into the spots I needed.
depends on your water, i wouldn’t want any drops of our nasty hard faucet water touching my coils or juice! my brain wants to say though that a few residue drops of faucet water wouldn’t alter/affect much.. either way if you have a blow dryer and tongs, you can use them to dry out moisture/water inside of ‘glass’ bottles.. i would think letting bottle sit outside in the direct sun for a little bit would work too.
Are your proportions of vg and pg in the juice proper i would imagine it would be quite hard to mix a flavoring in a almost full vg mix but I've never had issues with 80vg/20pg. I personally wouldn't toss it maybe it needs some time and i don't think a couple drops of tap water (unless you have some really nasty metalical tap water) could do much harm to the juice.
Go buy distilled water to do a final rinse on your bottles, I use it when I clean my tanks out as well.
I have a strong sense of taste and never detect anything from a couple water droplets of a rinsed bottle going into a full new bottle of juice.