15
CBD to replace Nic in Sub-ohm
submitted over 6 years ago by DaRaSC2

Hello,

​

I would like to stop using Nic and use CBD instead (most likely isolate mixed in my PG/VG + Heinsenberg concentrate)

My question is : Does any of you found a way to use CBD in sub-ohm ?

My standard build is : squonk mech + RSA 0.16 ohm

I know this is too low to use normal CBD eliquid, but what if I use a much lower concentrate than my "usual" 33mg/ml ?

Any feedback or suggestion please ?

Thanks

​

EDIT - TL;DR : On my pod .5 ohm 20 W my 33% CBD eliquid is just fine. On my allday RDA setup .16ohm 80W it is not vapable. Help me figure out why and how can I vape CBD at 80W

Comments
Sort
6 points
 
by Apexifiedover 6 years agoSuckling from the teats of Daenerys Targaryen

Your No-Frills guide to DIY cbd ejuice

2 points
 
by DaRaSC2over 6 years ago

Thanks but that's indeed the guide I use to mix CBD, but my question is more about CBD with subohm than how to mix CBD

4 points
 
by Apexifiedover 6 years agoSuckling from the teats of Daenerys Targaryen

My bad, I assumed the answer was in there because I know practically nothing about mixing CBD. Is there some reason it's different in a subohm setup vs MTL? /u/isuamadog

2 points
 
by DaRaSC2over 6 years ago

Yeah I tried to vape this in my normal setup andddddddd that's whas definitely not enjoyable :D

I would guess it's mainly because MTL usually vape in the 5-25W range, whereas I vape in 60-80W range. And it might be because it actually "burn" the little CBD crystals. But I am for sure no expert, so I could be totally wrong. What I know for sure is 33mg/ml in my setup isn't vapable

2 points
 
by isuamadogover 6 years ago

I only got the job of writing it because I’ve done it before and it’s not really been covered here. I’m a regular mtl vaper so I never really looked into whether there are any issues as to impact on efficacy, safety, issues with higher watts etc. I mean, intuitively I’d say it’s like any other additive But since it’s a medicinal thing, the regular answer of try it and find out sort of doesn’t apply. I tried to avoid making any claims past “mix/shake/vape”. r/cbd may actually be a better place to ask this time.

1 points
 
by Vaping_Ninja68over 6 years ago

I set my wife up a cheap aio for her cbd. With the price of isolate in the UK less vapor = less waste imo.

1 points
 
by DaRaSC2over 6 years ago

Right now I use my LostVape Orion for CBD. But as I said, my target is to use CBD with my everyday setup

1 points
 
by Vaping_Ninja68over 6 years ago

She run 0.5 coils @ 33.3%, still a little harsh but worth for the benefits. She r find that suckling a halls lozenge helps with the harshness.

1 points
 
by DaRaSC2over 6 years ago

That's also what I do, 0.5 20W 33.3%

1 points
 
by Vaping_Ninja68over 6 years ago

Try to setup around the 0.5 ohm range.

1 points
 
by DaRaSC2over 6 years ago

I do

1 points
 
by offengineerover 6 years ago

I haven't had a problem vaping cbd in my sub ohm. I use a round wire coil at .5 ohms around 22-26 Watts. No burning or distaste.

1 points
 
by DaRaSC2over 6 years ago

Yes me too, but I seem to have a problem when I go about 50-80W

4 points
 
by Dick_biglyover 6 years ago

Don't go 50-80w then.

1 points
 
by TKEOP867over 6 years ago

50-80W seem high for a .5 ohm coil. Maybe try building lower?

1 points
 
by DaRaSC2over 6 years ago

I think you might have read a bit too fast or I might not have been very clear :

I do vape on a 0.5 ohm coil (LostVape Orion pod) at 20W : and here my CBD DIY eliquid is fine.The point of this reddit post is to help me figure out how to be able to stop nicotine and use CDB instead on my allday setup which is about 0.16ohm and 80W.

1 points
 
by Nibeskingover 6 years ago

Have you tried to lower the CBD percentage for sub-ohm? Might be less harsh and vaporize better. Less molecules vaporizing at the same time, less risk of temperature rising and “burn” I m probably wrong.. this is just a hipóteses..

1 points
 
by DaRaSC2over 6 years ago

Yeah that's what I was thinking about. Kinda looking for feedback from people doing it at higher W than typical MTL

0 points
 
by Vaping_Ninja68over 6 years ago

You should be goo to go then. Quick draws and hold it in as long as possible.

-7 points
 
by Chewy__Bravoover 6 years ago

Central Business District? Wot?

6 points
 
by OutOfBounds11over 6 years agoFrugivore

The world is at your fingertips.

-9 points
 
by Chewy__Bravoover 6 years ago

I was obviously joking I've probably smoked more weed than you've pulled out of your mamma's garden, fuck off with this shit.

8 points
 
by OutOfBounds11over 6 years agoFrugivore

You need to smoke more weed. It obviously hasn't mellowed you at all.

Good luck to you.

Site copyright © 2025 DIY Compendium. Data courtesy of Reddit.