i was lazy. GF vibe worked http://i.imgur.com/6rTX7N5.jpg

I don't know why people do all this crazy-ass shaking stuff. I just set the bottle in hot water for a few min to thin, shake the shit out of it for a few seconds and that's it. Everything turns out great.

I made this jig from a small clamp I bought at Walmart (home depot has them also) and just drilled out an old blade from my sawzall and out a small screw through it to hold the clamp to the blade....works with a jigsaw as well. In 10 seconds your juice will be mixed as if you shook it for an hour.

Imgur

Do a lively jig. Or ask this guy to hold it for a while.

I use a drill. Put the top of the cap on the drill tip, and , using your finger nails, hold it in place so it can spin with the drill.

I took a single blade from an electric knife, wrapped it tight with a cloth and a couple rubber bands. Then strapped a couple bottles to that with rubber bands and turned it on.. Works like a charm

I use a little battery operated milk frother. seems to work well

http://imgur.com/MrrEvJb Servo mounted to a chunk of 2x4. Wall anchor box which can stand 6 30 ml bottles inside. Spins maybe about 30 times per minute. Powered by old 18650s. A fresh charged battery will tumble for more than 24 hours. It's ugly, It's not quiet but it was free. All parts were laying around the house and uses my non-married 18650s that I only use in my mech mods.

Edit: servo is configured for continuous rotation.

Ultrasonic.

I did a DIY Magnetic mixer a few months back. Here's a little action shot of it doing its job. Only cost $30

After I make a recipe, I put the bottle in a hot bath for 5 minutes. Hottest water I can get out of my faucet. Then I just use a 1ml serynge, insert the tip in the 30ml bottle just a little bit, and pump the serynge about 50 times and it creates so much bubbles in the bottles that it takes 3-4 hours before the liquid becomes clear again.

The key here is not to fully insert the tip in the juice so that way you pump air and juice in the serynge. If you aren't generating bubbles, play with it a little, it will definately work. It makes miracles for me

I have taped my bottles to a cordless, variable speed jig saw. The juice came out looking like milk until the air bubbles dissipated about 30 min later! If you have a tool like this it's the BEST method!!

Yeah! Science bitch! http://i.imgur.com/5kgMNfh.jpg

Dremel tool on high, turns to complete froth in under 10 seconds. I mix it for +/- 30 seconds then let it sit for a week or so depending on the flavors in question. Works well enough for me....

I fold a piece of kanthal in half so it looks like one of the wires on a metal whisk. Stick the two ends in a drill, put the fold in the beaker of juice. Mix away.

Small bar clamp with the end filed down, inserted into a reciprocating saw. Works a champ.

I tape my bottle to the end of my Shake Weight. By the time I'm done jerking my Shake Weight, not only do I have a sweet pump, but I also have some nicely steeped, frothy juice.

I sit the bottle in a warm water bath to thin the liquid for ~10 mins then I insert the tip of a 30ml syringe and pump the plunger half a dozen times rapidly to force the contents to mix under pressure. Dont know that it works any better or worse than anything else, just a habit that I got into that has had good results.

I'm planning to Velcro a box to the top of my dryer. Warm and vibratey!

20g kanthal to make a whisk. I usually make 2 or 3 "U"s. Attach it to your drill. No hotspots :)