3d Steeper set to 55C

submitted over 10 years ago by mcarter14777

Comments

2 points

by rakeleerover 10 years agoOne of "The Damned"

Not sure what I'm looking at, but it's inspiring.

1 points

by mcarter14777over 10 years ago

I use my 3d printers heated bed to steep juice

1 points

by ThirdWorldOrderover 10 years ago

What in the hell is that monstrosity?! I want one..

1 points

by mcarter14777over 10 years ago

Prusa i3 3D printer. My most beautiful monstrosity.

1 points

by NoiseBOXover 10 years ago

I've thought about doing this on my Prusa i3! Sadly i only have plastic dropper bottles as of the moment, i'll wait to order some glass ones.

How long do you steep it for? Have you played with different temperatures?

1 points

by mcarter14777over 10 years ago

I only steeped for 6 hours overnight, I'll probably give it another go with a beaker and some water with a slightly higher temp.. At 55c, with only bottom contact, I doubt it worked as well as letting bottles sit in front of a space heater

1 points

by monkey804over 10 years ago

Where's your enclosure, man? I don't see any insulation on the bottom of the bed. You're losing heat, man.

1 points

by mcarter14777over 10 years ago

Thanks for looking out but I'm using silicone adhered rubber pipe insulation.. Just can't see it

1 points

by monkey804over 10 years ago

Oh you fancy. :)