How do I fix the negative PG in the diy calculator?

submitted over 11 years ago by ping_pong_playa1

Comments

2 points

by tekhawkover 11 years ago

Use either higher MG nic or VG based nic. Your ratio is off because of the amount of PG based flavors and PG based nic.

2 points

by tekhawkover 11 years ago

Actually at looking a second time the only way 24mg based can make 50 / 50 would be to do half nic base and half VG..... You ordered totally the wrong nic base for what you want to do.

1 points

by ping_pong_playa1over 11 years ago

Could I mix half pg with that and make 12mg 50/50?

1 points

by ping_pong_playa1over 11 years ago

Nvm, still won't work

2 points

by tekhawkover 11 years ago

The only way you could is if you made it flavorless

1 points

by ping_pong_playa1over 11 years ago

I will be able to make the juice at 8 mg. thanks for your help. I'm new and didn't want to start with too high of mg just yet. In my mind I was just going to cut it in half, but as I can see now, it just doesn't work that way. Thanks again for your help

1 points

by PiCrustover 11 years ago

Did you figure it out? Whatcha makin?

2 points

by ping_pong_playa1over 11 years ago

Honey Peary clone. I just have to drop the mic mg a little.

1 points

by MisterEggsover 11 years ago

If you still want to keep the PG/VG ratio the same, you need some non-nic PG.

Personally i just adjust my PG/VG ratio until the PG isn't negative. It rarely strays more than 5 either way (as in between 45/55)