Thought you guys could appreciate my DIY mix station (reclaimed oak barn beam)...

submitted over 11 years ago by Jesus_Died_LOL_84

Comments

3 points

by [deleted]over 11 years ago

I used to get wood like that when I was young :-) (pun intended)

1 points

by MRMiller96over 11 years ago

What size bit do you use to drill the holes for the flavor bottles?

2 points

by Jesus_Died_LOL_84over 11 years ago

I used an 11/16" paddle bit on a drill press to accurately cut the holes for the bottles... i would suggest cutting them without a press unless you don't mind loose fitting holes... I tried doing it with a drill at first and the look and fit were very sloppy...